Product Description
Powerglide Tailhousing - Turbo 400 Roller Bearing PGH2R
The Reid Racing, Inc. tailshaft housings are designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock yet weighs only 4-1/2 pounds.
- Bolt in replacement – length and crossmember mounting flange is exactly the same as stock.
- Double lip seal.
- Relocated vent puts an end to the problem of trans fluid spraying out of breather.
- Completely pre-assembled.
- Includes a hardware kit with everything you need to bolt it on.
Special Note: No speedometer cable provision is supplied.
This model is used when the Superglide has a Turbo 400 output shaft. The driveshaft yoke is supported by a roller bearing instead of a bushing. A special hardened oversize Turbo 400 yoke is required (see yoke section).
